DUPLI-PIC
16x8x
Stand-Alone
Copier , No Computer

DUPLI-PIC
16x8x is a low-cost hand-held device intended to copy the contents
of the master PIC16x8x chip to any number of target chips. It can be
quite useful for small to medium volume programming. The Copier has the
following features:
-
Direct support for all Microchip’s
18-pin PIC16x8x devices
-
Includes a ZIF socket for DIP packages +
5-pin expansion header for in-system programming (any packages)
-
Read Master and Program functions
-
Automatic code protection removal during
Read Master sequence
-
Reading and programming the complete
contents of the chip including Program memory, configuration bits
(fuses), ID words and Data EEPROM
-
Code protection state of the programmed
chip can be chosen by the dedicated switch
-
Manufacturer approved programming
algorithm
-
Operates as a standalone unit (internal
non-volatile buffer: 1K x 16)
-
Very simple operation control using just
two buttons
-
Clear indication of the device status by
the multi-colored LED
-
Safe chip insertion/removal by switching
all device pins (including Vdd and Vpp) to ground when idle
-
High-quality PCB
-
Operates from external power supply: 15V
/ 100mA
(not included,
available at any electronics store)
-
Dimensions: 55mm x 40mm x 15mm
The following devices are supported by the Copier:
PIC16C84, PIC16LC84, PIC16F83, PIC16LF83, PIC16F84, PIC16LF84,
PIC16F84A, PIC16LF84A.
Note:
The Copier's code-protection removal feature for the PIC16F8x devices
has been weakened intentionally. For
almost 100% success in code-protection removal please refer to our
PROGRAM-A-CHIP Universal Chip Programmer.
$69.99
|